Switch L3/ Router Cisco Catalyst 6506 - SUP720-3BXL - https://myserver.md/produs/switch-l3-router-cisco-catalyst-6506-sup720-3bxl

Router show version: Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2011 by Cisco Systems, Inc. Compiled Wed 22-Jun-11 18:03 by prod_rel_team

ROM: System Bootstrap, Version 12.2(17r)SX5, RELEASE SOFTWARE (fc1)

Router uptime: is 6 minutes Uptime for this control processor is 6 minutes Time since Router switched to active is 5 minutes System returned to ROM by reload at 15:00:24 EEST Sat Jan 20 2024 (SP by reload) System image file is "sup-bootdisk:s72033-adventerprisek9_wan-mz.122-33.SXJ1.bin"

Processor board: ID SAL1133XUXE

Cisco WS-C6506-E (R7000) processor (revision 1.1) with 983008K/65536K bytes of memory. SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache Last reset from s/w reset 1 Virtual Ethernet interface 50 Gigabit Ethernet interfaces 1917K bytes of non-volatile configuration memory. 8192K bytes of packet buffer memory.

65536K bytes of Flash internal SIMM (Sector size 512K). Configuration register: is 0x2102

Router show platform hardware pfc mode - PFC operating mode: PFC3BXL

Router show platform hardware capacity forwarding L2 Forwarding Resources: MAC Table Usage Module Collisions Total Used Used %

--------------- ------ ---------- ---------- ------ 5 0 65536 2 1%

VPN CAM usage Total Used Used %

------------- ---------- ------ 512 0 0% L3 Forwarding Resources: FIB TCAM usage Total Used Used %

------------------------- ------- ----- ------- 72 bits (IPv4, MPLS, EoM) 1032192 20 1% 144 bits (IP mcast, IPv6) 8192 8 1%

Detail:

Protocol Used Used %

----------- ---- ------ IPv4 20 1% MPLS 0 0% EoM 0 0%

IPv6 1 1% IPv4 mcast 4 1% IPv6 mcast 3 1%

Adjacency usage Total Used Used %

--------------- ---------- ------ 1048576 168 1%

Forwarding engine load: Module Pps Peak-pps Peak-time

------ --- -------- ----------------------------- 5 8 20 13:19:23 UTC Sat Jan 20 2024

Router show power: system power redundancy mode = redundant system power redundancy operationally = non-redundant system power total = 2771.16 Watts (65.98 Amps @ 42V) system power used = 1081.08 Watts (25.74 Amps @ 42V) system power available = 1690.08 Watts (40.24 Amps @ 42V) Power-Capacity PS-Fan Output Oper PS Type Watts A @42V Status Status State -- ------------- ----- ------ ------ ------ ----- 1 WS-CAC-3000W 1171.38 27.89 - - OFF 2 WS-CAC-3000W 2771.16 65.98 OK OK ON

Pwr-Allocated Oper Fan Type Watts A @42V State --- -------------- ----- ------ ----- 1 WS-C6506-E-FAN 98.70 2.35 OK Pwr-Requested Pwr-Allocated Admin Oper Slot Card-Type Watts A @42V Watts A @42V State State ---- ---------------- ------- ------ ------- ------ ------ ----- 2 WS-X6748-GE-TX 325.50 7.75 325.50 7.75 ON ON 5 WS-SUP720-3BXL 328.44 7.82 328.44 7.82 ON ON 6 (Redundant Sup) - - 328.44 7.82 - -

System auxiliary power mode = off system auxiliary power redundancy operationally = non-redundant system primary connector power limit = 7266.00 Watts (173.00 Amps @ 42V) system auxiliary connector power limit = 10500.00 Watts (250.00 Amps @ 42V) system primary power used = 1081.08 Watts (25.74 Amps @ 42V) system auxiliary power used = 0 Watt

Router show module: Mod Ports Card Type Model Serial Nr. --- ----- ------------------------------------- -------------- ----------- 2 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX SAD112300VM 5 2 Supervisor Engine 720 (Active) WS-SUP720-3BXL SAL1128U3CL

Mod MAC addresses Hw Fw Sw Status --- -------------------------------- ---- ----------- ------------ ------ 2 001b.d4ab.655c to 001b.d4ab.658b 2.6 12.2(18r)S1 12.2(33)SXJ1 Ok 5 0016.c85e.bca0 to 0016.c85e.bca3 5.4 8.5(4) 12.2(33)SXJ1 Ok

Mod Sub-Module Model Serial Hw Status --- --------------------------- -------------- ------------ ---- ------- 2 Centralized Forwarding Card WS-F6700-CFC SAL1020NJA1 2.0 Ok 5 Policy Feature Card 3 WS-F6K-PFC3BXL SAL1052CHBS 1.8 Ok 5 MSFC3 Daughterboard WS-SUP720 SAL1129UXC5 3.0 Ok

Mod Online Diag Status: --- ------------------- 2 Pass 5 Pass

Log Buffer (8192 bytes):

*Jan 20 13:18:57.791: RP: Currently running ROMMON from F1 region *Jan 20 13:19:03.939: %SYS-5-CONFIG_I: Configured from memory by console *Jan 20 13:19:07.291: %SYS-5-RESTART: System restarted -- Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2011 by Cisco Systems, Inc. Compiled Wed 22-Jun-11 18:03 by prod_rel_team *Jan 20 13:14:42.671: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output. *Jan 20 13:18:52.411: SP: SP: Currently running ROMMON from F1 region *Jan 20 13:19:06.504: %SYS-SP-5-RESTART: System restarted -- Cisco IOS Software, s72033_sp Software (s72033_sp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2011 by Cisco Systems, Inc. Compiled Wed 22-Jun-11 18:47 by prod_rel_team *Jan 20 13:19:07.084: %SYS-SP-6-BOOTTIME: Time taken to reboot after reload = 351 seconds *Jan 20 13:19:07.095: %OIR-SP-6-INSPS: Power supply inserted in slot 1 *Jan 20 13:19:07.243: %OIR-SP-6-INSPS: Power supply inserted in slot 2 *Jan 20 13:19:07.347: %C6KPWR-SP-4-PSOK: power supply 2 turned on. *Jan 20 13:19:14.175: %FABRIC-SP-5-CLEAR_BLOCK: Clear block option is off for the fabric in slot 5. *Jan 20 13:19:14.275: %FABRIC-SP-5-FABRIC_MODULE_ACTIVE: The Switch Fabric Module in slot 5 became active. *Jan 20 13:19:15.611: %DIAG-SP-6-RUN_MINIMUM: Module 5: Running Minimal Diagnostics... *Jan 20 13:19:23.231: %DIAG-SP-6-DIAG_OK: Module 5: Passed Online Diagnostics *Jan 20 13:19:24.867: %OIR-SP-6-INSCARD: Card inserted in slot 5, interfaces are now online *Mar 1 00:00:02.375: DaughterBoard (Centralized Forwarding Card)

Firmware compiled 03-Jun-11 12:45 by integ Build [100] Jan 20 13:20:05.659: %SYS-CFC2-5-RESTART: System restarted -- Cisco IOS Software, c6lc2 Software (c6lc2-SP-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2011 by Cisco Systems, Inc. Compiled Wed 22-Jun-11 18:02 by prod_rel_team Jan 20 13:20:05.663: CFC2: Currently running ROMMON from F1 region